residual moisture is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-02-10. Numbers and descriptions here follow the published literature rather than marketing material.
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
A freeze-dryer consists of a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. Vials, ampoules, or bulk trays hold the product during the cycle. The condenser traps water vapor as ice at a temperature lower than the product. Cycle development balances shelf temperature, chamber pressure, and time. Scale-up can be difficult because heat and mass transfer change with equipment size, so process analytical tools and conservative validation are often used.
Equipment for lyophilization includes a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. A refrigeration system cools the shelves and condenser below the product's freezing point. Process monitoring often uses Pirani and capacitance manometers, thermocouples, and resistance sensors. Cycle development balances product quality with time and energy use. Some products are annealed during freezing to improve crystallization of bulking agents. Open questions remain about scaling cycles between laboratory, pilot, and production freeze-dryers.
Lyophilization, also called freeze-drying, removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts free water into ice and may also produce a glassy phase. Primary drying then lowers chamber pressure so ice sublimes directly to vapor without passing through a liquid stage. Secondary drying raises the temperature modestly to remove bound water. The result is a porous, dry solid that usually reconstitutes quickly. Each stage influences pore structure, residual moisture, and stability.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | freeze-drying, lyophilisation, cryodesiccation | Lyophilization is common in pharmaceutical literature. |
| Typical chamber pressure during primary drying | 0.05–0.5 mbar (5–50 Pa) | Must remain below the triple point of water. |
| Typical shelf temperature during freezing | −40 to −20 °C | Lower temperatures may be used for eutectic systems. |
| Typical residual moisture after secondary drying | 0.5–3% w/w | Product-dependent; low moisture improves stability but can cause over-drying. |
| Typical analytical method for residual moisture | Karl Fischer titration or loss on drying | Thermogravimetric methods are also used. |
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
The physics of freeze-drying couples heat transfer, mass transfer, and phase change. Heat supplied through the shelf must reach the sublimation front without melting the ice or degrading the product. Water vapor then travels through the already dried layer and leaves the chamber, where low pressure and cold traps keep it from returning. The dried layer acts as a resistance to vapor flow, so drying rate changes as the front recedes. Open questions remain about how pore structure and formulation heterogeneity affect drying uniformity at larger scales.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and concentrates dissolved solids. Primary drying then lowers chamber pressure so ice changes directly into vapor without passing through a liquid phase. Secondary drying raises the shelf temperature to remove bound water that remains after ice sublimation. The result is a dry, porous structure that can be reconstituted later.
== Recombinant chymosin == Because of the imperfections and scarcity of microbial and animal rennets, producers sought replacements. With the development of genetic engineering, it became possible to extract rennet-producing genes from animal stomach and insert them into certain bacteria, fungi or yeasts to make them produce chymosin during fermentation. The genetically modified microorganism is killed after fermentation and chymosin is isolated from the fermentation broth, so that the fermentation-produced chymosin (FPC) used by cheese producers does not contain any GM component or ingredient. FPC contains the identical chymosin as the animal source, but produced in a more efficient way. FPC products have been on the market since 1990 and are considered the ideal milk-clotting enzyme. FPC was the first artificially produced enzyme to be registered and allowed by the US Food and Drug Administration. In 1999, about 60% of US hard cheese was made with FPC and it has up to 80% of the global market share for rennet. By 2008, approximately 80% to 90% of commercially made cheeses in the US and Britain were made using FPC. The most widely used fermentation-produced chymosin is produced either using the fungus Aspergillus niger or using Kluyveromyces lactis. FPC contains only chymosin B, achieving a higher degree of purity compared with animal rennet. FPC can deliver several benefits to the cheese producer compared with animal or microbial rennet, such as higher production yield, better curd texture and reduced bitterness.
South Korea has been described as an anchor along the first island chain. In 2025, a United States Forces Korea commander stated that US forces on the Korean Peninsula will expand their scope of operations to prepare for a potential defense of Taiwan.
== Fisheries == Food and Agriculture Organization of the United Nations: In 2014, Thailand ranked number 14 in the world in "marine capture" of fish (harvesting of ocean species), 1.6 million tonnes, number 15 in "inland capture" (harvesting of fresh water species), 210,293 tonnesm, number 13 in "farmed species", 934,800 tonnes, and was the fourth leading exporter of fish, with exports valued at US$6.6 billion.
== Societies == The more empirical approach to human and medical genetics was formalized by the founding in 1948 of the American Society of Human Genetics. The Society first began annual meetings that year (1948) and its international counterpart, the International Congress of Human Genetics, has met every 5 years since its inception in 1956. The Society publishes the American Journal of Human Genetics on a monthly basis. Medical genetics is recognized as a distinct medical specialty. In the U.S., medical genetics has its own approved board (the American Board of Medical Genetics) and clinical specialty college (the American College of Medical Genetics). The college holds an annual scientific meeting, publishes a monthly journal, Genetics in Medicine, and issues position papers and clinical practice guidelines on a variety of topics relevant to human genetics. In Australia and New Zealand, medical geneticists are trained and certified under the auspices of the Royal Australasian College of Physicians, but professionally belong to the Human Genetics Society of Australasia and its special interest group, the Australasian Association of Clinical Geneticists, for ongoing education, networking and advocacy.
== DNA-encoded chemical libraries and display technologies == Until recently, the application of molecular evolution in the laboratory had been limited to display technologies involving biological molecules, where small molecules lead discovery was considered beyond this biological approach. DELs have opened the field of display technology to include non-natural compounds such as small molecules, extending the application of molecular evolution and natural selection to the identification of small molecule compounds of desired activity and function. DNA encoded chemical libraries bear resemblance to biological display technologies such as antibody phage display technology, yeast display, mRNA display and aptamer SELEX. In antibody phage display, antibodies are physically linked to phage particles that bear the gene coding for the attached antibody, which is equivalent to a physical linkage of a “phenotype” (the protein) and a “genotype” (the gene encoding for the protein ). Phage-displayed antibodies can be isolated from large antibody libraries by mimicking molecular evolution: through rounds of selection (on an immobilized protein target), amplification and translation. In DELs the linkage of a small molecule to an identifier DNA code allows the facile identification of binding molecules.
Sources: en.wikipedia.org
Sertraline, sold under the brand name Zoloft among others, is an antidepressant medication of the selective serotonin reuptake inhibitor (SSRI) class used to treat major depressive disorder, generalized anxiety disorder, social anxiety disorder, obsessive–compulsive disorder (OCD), panic disorder, and premenstrual dysphoric disorder. Although also having approval for post-traumatic stress disorder (PTSD), findings indicate it leads to only modest improvements in symptoms associated with this condition. The drug shares the common side effects and contraindications of other SSRIs, with high rates of nausea, diarrhea, headache, insomnia, mild sedation, dry mouth, and sexual dysfunction, but it appears not to lead to much weight gain, and its effects on cognitive performance are mild. In some patients, sexual dysfunction may persist even after the drug is discontinued, a condition known as post-SSRI sexual dysfunction; regulatory agencies including the European Medicines Agency and Health Canada have recommended that sertraline's product labeling warn of this risk. Similar to other antidepressants, the use of sertraline for depression may be associated with a mildly elevated rate of suicidal thoughts in people under the age of 25 years old. It should not be used together with monoamine oxidase inhibitors (MAOIs): this combination may cause serotonin syndrome, which can be life-threatening in some cases. Sertraline taken during pregnancy is associated with an increase in congenital heart defects in newborns.
Cangrelor, sold under the brand name Kengreal among others, is a P2Y12 inhibitor FDA approved as of June 2015 as an antiplatelet drug for intravenous application. Some P2Y12 inhibitors are used clinically as effective inhibitors of adenosine diphosphate-mediated platelet activation and aggregation. It is authorized as a generic medication.
5-HTP robustly produces the head-twitch response (HTR) in rodents when administered at relatively high doses. It dose-dependently induces the HTR in mice across a dose range of 50 to 250 mg/kg via intraperitoneal administration, with an inverted U-shaped dose–response curve and maximal induction of the HTR at a dose of 200 mg/kg. Similarly to the case of 5-HTP, intracerebroventricular injection of serotonin, but not peripheral administration of serotonin, produces the HTR. The HTR is induced by serotonergic psychedelics like lysergic acid diethylamide (LSD) and psilocybin and is a behavioral proxy of psychedelic effects. The HTR of 5-HTP is blocked by serotonin 5-HT2A receptor antagonists, which block the hallucinogenic effects of serotonergic psychedelics in humans, is prevented by aromatic L-amino acid decarboxylase (AAAD) inhibitors, which block conversion of 5-HTP into serotonin, and is potentiated by monoamine oxidase A (MAO-A) inhibitors, which prevent the degradation of serotonin and other endogenous tryptamines. It is also suppressed by the serotonin 5-HT1A receptor full agonist 8-OH-DPAT, is greatly augmented by the serotonin 5-HT2C receptor antagonist RS-102221, and is reduced by the trace amine-associated receptor 1 (TAAR1) antagonist EPPTB.
On the morning of 8 September, representatives of the Fatherland Front - Kimon Georgiev, Nikola Petkov, Dimitar Neykov, Kiril Dramaliev and Dimo Kazasov - met with the Prime Minister, protesting the dispersal of opposition demonstrations in the previous days and demanding that rallies be allowed in the major cities. Kimon Georgiev hosted a meeting of the Fatherland Front's National Committee at 4 p.m. on 8 September. The government's composition was settled upon, and its policy text is approved. The composition of the future government and the new regents were specified at a meeting between Kimon Georgiev, Dobri Terpeshev, Nikola Petkov and Damyan Velchev at Georgiev's home at 4 pm on 8 September. It was agreed that the cabinet would include four representatives each of the BRP, Zveno and BZNS-Pladne, two of the BRSD and two independents, and that the prime minister would be Kimon Georgiev, a decision agreed with Soviet dictator Joseph Stalin. Georgiev spent the night of the coup with Damyan Velchev, Nikola Petkov, and Traicho Dobroslavsky at the home of Yanko Antonov near the Eagles Bridge - he was a neighbor of Peter Vranchev, in whose apartment the Communist leaders - Dobri Terpeshev, Anton Yugov, Georgi Chankov, Angel Tsanev, and Katya Avramova were at the time. The coup began at 2 a.m. on 9 September with the seizure of the War Ministry building. War Minister Ivan Marinov sided with the coup and issued the appropriate orders to the First Infantry Division and the School for Reserve Officers.
Sources: en.wikipedia.org
Yes, the terms are generally interchangeable. Lyophilization is more common in pharmaceutical and laboratory contexts, while freeze-drying appears widely in food science and general writing. Both describe removal of solvent by sublimation under vacuum after freezing.
Reduced pressure keeps the process below the triple point of water, so ice can sublimate directly to vapor. It also lowers the temperature needed for drying, which helps preserve heat-sensitive materials. Without vacuum, melting or boiling could occur instead of controlled sublimation.
The rate depends on heat transfer to the product and mass transfer of vapor through the dried layer. A cold condenser, adequate vacuum, and suitable shelf temperature all influence speed. Formulation properties such as solid content and collapse temperature also set practical limits.
Simple drying usually removes water by evaporation from a liquid or solid, often with heat. Lyophilization first freezes the material and then removes ice by sublimation under vacuum. This avoids prolonged exposure to liquid water and high temperatures.